Toyota Camry

1992-1997 of release

Repair and operation of the car


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
- 11. Coupling and power shafts
   11.2. General information
   + 11.3. Check and replacement of a disk of coupling
   + 11.4. Vyzhimna bearing
   - 11.5. Main cylinder of coupling
      11.5.2. Repair
      11.5.3. Installation
   + 11.6. Working cylinder of coupling
   11.7. Removal of air from hydraulic system of coupling
   11.8. Starting switch of coupling
   + 11.9. Hinge of Equal Angular Speeds (HEAS)
   + 11.10. Replacement of protective covers and repair of hinges of equal angular speeds
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


11.5.2. Repair
GENERAL INFORMATION

Details of the main cylinder of coupling
 
1 – spring pin;
2 – cover;
3 – float;
4 – tank;
5 – sealing ring;
6 – spring;
7 – pusher;
8 – lock ring;
9 – bracket;
10 – forelock;
11 – draft;
12 – protective cover;
13 – washer;
14 – piston;
15 – case of the main cylinder of coupling

PERFORMANCE ORDER
1. Uncover a tank and merge liquid from the main cylinder. Using a hammer and a drift, beat out a pin of fastening and remove a tank from the main cylinder of coupling (see rice. Details of the main cylinder of coupling).
2. Remove a dustproof cover from the case and take a lock ring.
3. Take a washer and a pusher from the cylinder case.
4. Knock with the coupling cylinder on wooden whetstone to take the piston from the case of the main cylinder.
5. Remove a spring from the piston.
6. Remove a sealing ring from the piston.
7. Wash out all details of the main cylinder of coupling in pure brake fluid and check their state.
8. Establish a sealing ring in a piston flute, thus working edges of a sealing ring have to be from outside, opposite to a pusher.
9. Establish a spring on the piston.
10. Grease an opening of the cylinder and working edges a sealant a ring foot with fresh brake fluid and, being careful, install the piston in the cylinder.
11. Establish a pusher with a washer, squeeze a spring and establish those a new lock ring.
12. Establish a dustproof cover and a tank on the main cylinder of coupling.