Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
- 11. Coupling and power shafts
   11.2. General information
   + 11.3. Check and replacement of a disk of coupling
   + 11.4. Vyzhimna bearing
   + 11.5. Main cylinder of coupling
   + 11.6. Working cylinder of coupling
   11.7. Removal of air from hydraulic system of coupling
   11.8. Starting switch of coupling
   + 11.9. Hinge of Equal Angular Speeds (HEAS)
   + 11.10. Replacement of protective covers and repair of hinges of equal angular speeds
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


11.7. Removal of air from hydraulic system of coupling

GENERAL INFORMATION

The union of pumping is located sideways the working cylinder of coupling.

PERFORMANCE ORDER
1. Unscrew a cover of a nutritious tank and check that the level of brake fluid in a tank was at the level of max tag. During removal of air watch availability of liquid in a tank, without allowing an exposure of its bottom as thus air will get to system again.
2. Remove a dustproof cap from the union of pumping and put on it a pure transparent hose which other end needs to be lowered in the capacity which is partially filled with brake fluid.
3. Sharply press a coupling pedal several times from intervals of 2 - 3 sec. Unscrew on a turn floor the pumping union at the pressed pedal. Continuing to press a pedal, force out the liquid which is in system together with air through a hose in capacity. After the pedal reaches extreme forward situation and replacement of liquid through a hose will stop, screw the pumping union to the full.
4. Repeat these operations, the air outlet from a hose will not stop yet.
5. Holding a pedal in the pressed situation, screw up the union against the stop and remove a hose.
6. Wipe the union of pumping and establish a protective cap.