Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
- 13. Suspension bracket
   13.2. General information
   + 13.3. Forward stabilizer of cross stability
   + 13.4. The lobby is resistant
   13.5. Repair of a forward rack
   + 13.6. Lower lever of a forward suspension bracket
   13.7. Replacement of the lower hinge of a forward suspension bracket
   + 13.8. Rotary fist
   13.9. Back stabilizer of cross stability
   - 13.10. Rack of a back suspension bracket
      13.10.2. Installation
   13.11. Longitudinal draft of a back suspension bracket
   + 13.12. Levers of a back suspension bracket
   + 13.13. Nave of a back suspension bracket
   + 13.14. Fastener of a back nave
   + 13.15. Steering wheel
   + 13.16. Tips of steering draft
   13.17. Replacement of protective covers of steering transfer
   + 13.18. Steering transfer
   + 13.19. Pump of the amplifier of a steering
   13.20. Removal of air from system of a steering with the amplifier
   + 13.21. Wheels and tires
   13.22. Corners of installation of wheels
+ 14. Body
+ 15. Electric equipment


13.10. Rack of a back suspension bracket

13.10.1. Removal

PERFORMANCE ORDER
1. On models with a body "sedan" remove a back seat and lateral finishing. On models with a body "station wagon" remove a back of a back seat and lateral finishing.
2. Lift back part of the car and record on supports. Remove back wheels.
3. On models with a body "station wagon" disconnect a spring of the limiter of pressure (LSPV) from the lower lever.
4. Remove a brake hose from an arm of a back rack.
5. Unscrew draft of the stabilizer from a back rack.
6. Support the fastener of a back nave a jack.
7. Weaken two nuts of fastening of a back rack to the nave fastener.
8. Unscrew three nuts of the top fastening of a back rack to a body.
9. A jack lower the fastener of a nave and an okonchatel but unscrew two nuts and take two bolts of fastening of the lower part of a back rack to the nave fastener.
10. Take a rack of a back suspension bracket from under the car.
11. Check of a state and dismantling of a rack of a back suspension bracket is made in the same way, as well as racks of a forward suspension bracket.


12. Make installation of the top support of a back rack according to drawing.