Toyota Camry

1992-1997 of release

Repair and operation of the car

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
- 13. Suspension bracket
   13.2. General information
   + 13.3. Forward stabilizer of cross stability
   + 13.4. The lobby is resistant
   13.5. Repair of a forward rack
   + 13.6. Lower lever of a forward suspension bracket
   13.7. Replacement of the lower hinge of a forward suspension bracket
   + 13.8. Rotary fist
   13.9. Back stabilizer of cross stability
   + 13.10. Rack of a back suspension bracket
   13.11. Longitudinal draft of a back suspension bracket
   + 13.12. Levers of a back suspension bracket
   + 13.13. Nave of a back suspension bracket
   - 13.14. Fastener of a back nave
      13.14.2. Installation
   + 13.15. Steering wheel
   + 13.16. Tips of steering draft
   13.17. Replacement of protective covers of steering transfer
   + 13.18. Steering transfer
   + 13.19. Pump of the amplifier of a steering
   13.20. Removal of air from system of a steering with the amplifier
   + 13.21. Wheels and tires
   13.22. Corners of installation of wheels
+ 14. Body
+ 15. Electric equipment

13.14. Fastener of a back nave

13.14.1. Removal

GENERAL INFORMATION

Fastener of a nave of a back suspension bracket

1 – wheel speed sensor;
2 – fastener of a back suspension bracket;
3 – support;
4 – nave;

5 – brake disk;
6 – sealing ring of round section

PERFORMANCE ORDER

1. Lift back part of the car and record on supports. Remove a back wheel.

2. Remove the back brake drum or a support and a brake disk. On models with back brake drums of an otsoyeda to Nita a brake tube from the working brake cylinder.

3. Remove a back nave.

4. On models with back brake drums remove a brake board from the nave fastener. On models with back disk brakes remove a brake board and knot of the emergency brake from the nave fastener. Using a soft wire, tie a brake board to a spring of a back suspension bracket.

5. On models with anti-blocking system unscrew the wheel speed sensor from the nave fastener.

6. On models with a body "station wagon" unscrew a nut of fastening of a spring of the restrictive valve (LSPV).

7. Weaken bolts of fastening of a rack of a back suspension bracket to the fastener of a back nave.

8. Unscrew bolts of fastening longitudinal and cross levers to the fastener.

9. Finally unscrew bolts of fastening of a rack of a back suspension bracket to the fastener of a back nave and remove the fastener of a back nave.