Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
- 13. Suspension bracket
   13.2. General information
   + 13.3. Forward stabilizer of cross stability
   + 13.4. The lobby is resistant
   13.5. Repair of a forward rack
   + 13.6. Lower lever of a forward suspension bracket
   13.7. Replacement of the lower hinge of a forward suspension bracket
   + 13.8. Rotary fist
   13.9. Back stabilizer of cross stability
   + 13.10. Rack of a back suspension bracket
   13.11. Longitudinal draft of a back suspension bracket
   + 13.12. Levers of a back suspension bracket
   + 13.13. Nave of a back suspension bracket
   + 13.14. Fastener of a back nave
   + 13.15. Steering wheel
   + 13.16. Tips of steering draft
   13.17. Replacement of protective covers of steering transfer
   - 13.18. Steering transfer
      13.18.2. Installation
   + 13.19. Pump of the amplifier of a steering
   13.20. Removal of air from system of a steering with the amplifier
   + 13.21. Wheels and tires
   13.22. Corners of installation of wheels
+ 14. Body
+ 15. Electric equipment


13.18. Steering transfer

13.18.1. Removal

GENERAL INFORMATION

Elements of fastening of steering transfer
 
1 – forelock;
2 – protection of the right forward wing;
3 – stabilizer of cross stability;
4 – protection of the left forward wing;
5 – forelock

PERFORMANCE ORDER
1. Establish forward wheels for the movement directly forward. Lift forward part of the car and record on supports. Remove wheels. Remove an engine mudguard.

2. Install the corresponding container under steering transfer and disconnect from steering transfer, the giving and returnable tubes and close them traffic jams.
3. Note mutual position of the lower universal hinge and an entrance shaft of steering transfer. Unscrew lower tightening a bolt of an intermediate shaft.
4. Remove spherical hinges of tips of steering draft from rotary fists.
5. Unscrew bolts of fastening of plugs of the stabilizer of cross stability.
6. Unscrew nuts of fastening of steering transfer, raise the stabilizer of cross stability and take bolts of fastening of steering transfer.
7. Remove an intermediate shaft from an entrance shaft of steering transfer and take steering transfer from the right side of the car.