Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
- 13. Suspension bracket
   13.2. General information
   + 13.3. Forward stabilizer of cross stability
   + 13.4. The lobby is resistant
   13.5. Repair of a forward rack
   + 13.6. Lower lever of a forward suspension bracket
   13.7. Replacement of the lower hinge of a forward suspension bracket
   + 13.8. Rotary fist
   13.9. Back stabilizer of cross stability
   + 13.10. Rack of a back suspension bracket
   13.11. Longitudinal draft of a back suspension bracket
   + 13.12. Levers of a back suspension bracket
   + 13.13. Nave of a back suspension bracket
   + 13.14. Fastener of a back nave
   + 13.15. Steering wheel
   + 13.16. Tips of steering draft
   13.17. Replacement of protective covers of steering transfer
   + 13.18. Steering transfer
   + 13.19. Pump of the amplifier of a steering
   13.20. Removal of air from system of a steering with the amplifier
   - 13.21. Wheels and tires
      13.21.2. Replacement of wheels
      13.21.3. Running in of tires
      13.21.4. Storage of tires
      13.21.5. Balancing of wheels
      13.21.6. Antisliding chains
      13.21.7. Check of pressure in tires
      13.21.8. Check of a profile of tires
   13.22. Corners of installation of wheels
+ 14. Body
+ 15. Electric equipment


13.21.8. Check of a profile of tires

GENERAL INFORMATION

Preventions

Tires can be operated to achievement of depth of a profile of 1,6 mm, that is flutes of a profile have to have depth on all surface of the tire not less than 1,6 mm. However for safety it is recommended to make change of tires with a depth of profile of 3 mm.

Tires M+S on snow have sufficient coupling with the road with a depth of profile not less than 4 mm.

It is necessary to survey the tire on existence of cuts and to establish their depth. If cuts reach a cord, the steel cord will korrodirovat from the getting moisture.


Intensive wear of tires is promoted by a sports manner of driving, intensive accelerations and sharp braking.