Toyota Camry

1992-1997 of release

Repair and operation of the car

Kamri's Toyota
+ General data
- 1. Maintenance
   1.2. Frequency of service
   - 1.3. Maintenance
      + 1.3.1. Each 400 km or weekly
      + 1.3.2. Each 5 000 km or 3 months
      + 1.3.3. Each 10 000 km or 6 months
      - 1.3.4. Each 25 000 km or 12 months
         - 1.3.4.1.1. Disk brakes
            1.3.4.1.2. Drum brakes
            1.3.4.1.3. Check of the vacuum amplifier of brakes
            1.3.4.1.4. Check of the emergency brake
            1.3.4.1.5. Free wheeling and height of installation of a pedal of a brake
         1.3.4.2. Replacement of the air filter
         1.3.4.3. Check of fuel system
         1.3.4.4. Check of level of oil in the main transfer
         + 1.3.4.5. Check of a suspension bracket and steering
         1.3.4.6. Check of a protective cover of a power shaft
      + 1.3.5. Each 50 000 km or 24 months
      + 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

1.3.4.1.5. Free wheeling and height of installation of a pedal of a brake

PERFORMANCE ORDER

	1. Measure brake pedal height in a starting position.
2. For adjustment of height of installation of a pedal of a brake remove the switch of a stoplight and weaken a lock-nut on a pusher of the vacuum amplifier of brakes.
3. Turn of a pusher adjust height of installation of a pedal of a brake and tighten a lock-nut.

4. Install the switch of a stoplight and measure distance between an emphasis of a pedal of a brake and the case of the switch of a stoplight.	5. For adjustment of position of the switch of a stoplight weaken a lock-nut on the switch and, rotating a vyklyuchvtel of a stoplight, establish the demanded gap and tighten a lock-nut.	6. Press a brake pedal by small effort and measure distance from a starting position of a pedal before situation at which you will feel resistance.

7. Start the engine, press a brake pedal against the stop and measure distance from a pedal to a floor.	8. If the minimum height of a pedal, in the pressed situation is less demanded, check brake system for existence of leaks or other damages.