Toyota Camry

1992-1997 of release

Repair and operation of the car


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
- 10. Automatic transmission
   10.2. General information
   + 10.3. Diagnostics
   - 10.4. Adjustment and replacement of a cable of a choice of transfers
      10.4.2. Replacement
   10.5. Check and adjustment of a cable of management of a butterfly valve
   + 10.6. Check, replacement and adjustment of the switch of blocking of a starter
   + 10.7. Lock of blocking of the lever of a choice of transfers
   + 10.8. Replacement of sealing rings
   + 10.9. Check and replacement of support of a transmission
   10.10. Electronic control system
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


10.4. Adjustment and replacement of a cable of a choice of transfers

10.4.1. Adjustment
GENERAL INFORMATION

When moving the lever of a choice of transfers from neutral it has to move to other provisions smoothly and accurately be fixed. Thus the indicator of position of the lever has to specify the correct position of the lever. If the indicator does not show the correct position of the lever, adjust a cable of a choice of transfers as follows.

PERFORMANCE ORDER
1. Lift the car and record on supports. Remove mudguards.
2. Weaken a nut of fastening of a hinged bolt of a cable of a choice of transfers on the lever of a choice of transfers of a transmission.
3. Move the lever of a choice of transfers against the stop down, then return back it on 2 provisions and establish in neutral situation.
4. Install the lever of a choice of transfers in salon of the car to neutral situation.
5. Tighten a nut of fastening of a hinged bolt of a cable of a choice of transfers on the transmission lever.
6. Check action of a transmission in each position of the lever of a choice of transfers. At start of the engine the starter has to work only in the position PARK or NEUTRAL of the lever of a choice of transfers.