Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
- 15. Electric equipment
   15.2. General information
   15.3. Electric chains
   + 15.4. Detection of not closed chain
   15.5. Safety locks
   15.6. Relay
   + 15.7. Multipurpose switches of a steering column
   + 15.8. Ignition lock
   15.9. Switch of a heater of back glass
   15.10. Check of a heater of back glass
   15.11. Radio receiver
   15.12. Loudspeakers
   15.13. Antenna
   15.14. Replacement of bulbs of headlights
   15.15. Adjustment of light of headlights
   15.16. Headlight
   + 15.17. Replacement of bulbs of an incandescence
   + 15.18. Screen wiper engine
   15.19. Combination of devices
   15.20. Sound signal
   15.21. System cruise control
   15.22. Window regulators with the electric drive
   15.23. System of the central blocking of locks
   15.24. Rear-view mirrors with the electric drive
   15.25. Safety airbag
   + 15.26. Schemes of electric equipment


15.10. Check of a heater of back glass

GENERAL INFORMATION

The heater of back glass represents a set of the horizontal conductors which are raised dust on an internal surface of back glass.

PERFORMANCE ORDER
1. For detection of a rupture of the conductor of a heater of back glass include ignition and the switch of a heater of back glass.
2. Connect one probe of the voltmeter to the mass of the car, and wrap up the second probe a foil and move a foil on the heater conductor.
3. Connect the voltmeter probe in the center of each conductor of a heater of back glass. If the voltmeter shows voltage about 5 V, the conductor of a heater means is serviceable. If the voltmeter shows voltage of 0 V or 12 V, means there is a rupture of the conductor of a heater.

4. For detection of a place of a rupture of the conductor of a heater connect one probe of the voltmeter to the positive plug of a heater, and move the second probe on the heater conductor from the negative plug of a heater. The point in which tension shown by the voltmeter will reduce from several volts to zero and is a place of a rupture of the conductor of a heater.