Toyota Camry

1992-1997 of release

Repair and operation of the car


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
- 8. Toxicity decrease
   8.2. General information
   8.3. System of electronic control (TCCS)
   8.4. System of self-diagnostics
   - 8.5. Sensors
      8.5.2. Oxygen sensor
      8.5.3. Sensor of provision of a butterfly valve
      8.5.4. Air stream measuring instrument (only engines 3VZ-FE V6)
      8.5.5. MAF sensor of measurement of mass of a stream of air (engine 1MZ-FE V6)
      8.5.6. Sensor of absolute pressure (four-cylinder engines)
      8.5.7. EGR temperature sensor
      8.5.8. Car speed sensor
      8.5.9. The detonation sensor (only with V6 engines)
      8.5.10. Sensor of provision of a camshaft (engine 1MZ-FE V6)
      8.5.11. Sensor of an angle of rotation of a cranked shaft (only engines 1MZ-FE V6)
   + 8.6. Induction system of air supply in the engine (ACIS)
   8.7. System of catching of vapors of fuel (EVAP)
   + 8.8. System of repeated burning of exhaust gases (EGR)
   8.9. System of ventilation of a case (PCV)
   8.10. Catalyst
   8.11. Codes of malfunctions
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


8.5.5. MAF sensor of measurement of mass of a stream of air (engine 1MZ-FE V6)
GENERAL INFORMATION

Check of resistance the sensor of measurement of mass of a stream of air at warming up of the engine (engine 1MZ-FE V6)
  

The sensor of measurement of mass of a stream of air is located in the inlet canal. Operation of the sensor is based on measurement soprotiv the line of the heated conductor cooled by an air stream.

PERFORMANCE ORDER
1. Disconnect the electric socket from the sensor and at inclusion of ignition check that on a black/orange wire there is accumulator tension.

2. Connect the electric socket to the sensor of measurement of mass of a stream of air and connect the voltmeter to contacts of VG and VG-. At the included ignition, but not working engine tension has to be less, than 1,0 Century. After start of the engine tension has to increase till 2 Century.

3. Check resistance between contacts of THA and E2 of the socket of the sensor of measurement of mass of a stream of air. Resistance of the sensor has to change at warming up of the engine.
4. For removal by the sensor of measurement of mass of a stream of air disconnect from it the electric socket, remove a casing of the air filter, unscrew 4 bolts and remove the sensor.