Toyota Camry

1992-1997 of release

Repair and operation of the car


Kamri's Toyota
+ General data
- 1. Maintenance
   1.2. Frequency of service
   - 1.3. Maintenance
      + 1.3.1. Each 400 km or weekly
      - 1.3.2. Each 5 000 km or 3 months
         1.3.2.2. Control of level of oil in an automatic transmission
         1.3.2.3. Replacement of oil and oil filter
      + 1.3.3. Each 10 000 km or 6 months
      + 1.3.4. Each 25 000 km or 12 months
      + 1.3.5. Each 50 000 km or 24 months
      + 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


Компания Трейдомед Инвест предлагает фундуС- КАМЕРЫ Topcon.

1.3.2.2. Control of level of oil in an automatic transmission
GENERAL INFORMATION
Prevention

Never allow that the level of oil was more top mark.

The probe for measurement of level of oil in an automatic transmission

Probe arrangement for measurement of level of oil in an automatic transmission
 If a transmission cold, the level of oil has to be between two lower tags, and at a hot box – between two top tags.

Oil level in an automatic transmission – an important operational indicator. Both low, and high level of oil is not allowed.

PERFORMANCE ORDER
1. Carry out a short trip on the car to heat transmission to normal temperature.
2. Install the car on an equal horizontal surface. Idling the engine, the tightened hand and foot brake, move the selector handle on all positions and return to a starting position (Park). In this position of the selector and engine idling take the probe for measurement of level of oil and along with a mark of level estimate a condition of oil.
3. Wipe the probe and install it into place.
4. Repeatedly take the probe and measure oil level. If a transmission cold, the level of oil has to be between two lower tags on the probe. If the transmission is heated-up up to the normal working temperature, the level of oil has to be between two top tags on the probe.
5. If oil level low, add it through an opening for the probe. The distance between tags corresponds to about 1 l of oil. Add oil in the small portions. If color of oil black or brown, oil it is necessary to replace. If you doubt quality of oil, compare a sample of the fresh oil and oil which is in a transmission.