Repair and operation of the Toyota Camry car - 1.3.3.4. Check and replacement of a driving belt//Kamri's Toyota of 1992-1997 /

Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
- 1. Maintenance
   1.2. Frequency of service
   - 1.3. Maintenance
      + 1.3.1. Each 400 km or weekly
      + 1.3.2. Each 5 000 km or 3 months
      - 1.3.3. Each 10 000 km or 6 months
         1.3.3.1.1. Type A
         1.3.3.1.2. Type B
         1.3.3.2. Check of a free wheeling and height of installation of a pedal of coupling
         + 1.3.3.3. Check and service of the accumulator
         - 1.3.3.4. Check and replacement of a driving belt
            1.3.3.4.2. Adjustment
            1.3.3.4.3. Replacement
         + 1.3.3.5. Check of tightness of hoses and effluence of liquids
         1.3.3.6. Check of the cooling system
         1.3.3.7. Change of provision of installation of tires
      + 1.3.4. Each 25 000 km or 12 months
      + 1.3.5. Each 50 000 km or 24 months
      + 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


êàòåð äëÿ ðûáàëêè

1.3.3.4. Check and replacement of a driving belt

1.3.3.4.1. Check

GENERAL INFORMATION

Driving belts are located on the right side of the engine.

Depending on a complete set of the car and the engine installed in it, some driving belts are used. One belt is used for a torque transmission from a cranked shaft to the generator and the compressor of the conditioner. If the car is equipped by the amplifier of a steering, for the drive of the pump of the amplifier of a steering to an ispolz the separate belt etsyatsya.

PERFORMANCE ORDER
1. Open the cover closing belts and check a condition of belts for existence of cracks, stratifications and oiling. If necessary replace a belt.
2. For check of a tension of a driving belt use the special Nippondenso or Burroughs tools. A tension for the new and being in the use belt differ. Being in the use it is considered a belt which worked on the engine more than 5 minutes.
3. In the absence of special tools the tension of a driving belt needs to be adjusted so that when pressing by a hand thumb on a long branch of a belt the deflection made about 5 mm if the distance between the central pulleys makes about 250 mm, or 10 mm if the distance between the central pulleys makes about 350 mm (1 – a ruler, 2 – a ruler, 3 – a belt deflection).