Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
- 1. Maintenance
   1.2. Frequency of service
   - 1.3. Maintenance
      + 1.3.1. Each 400 km or weekly
      + 1.3.2. Each 5 000 km or 3 months
      + 1.3.3. Each 10 000 km or 6 months
      + 1.3.4. Each 25 000 km or 12 months
      - 1.3.5. Each 50 000 km or 24 months
         - 1.3.5.2. Replacement of cooling liquid
            1.3.5.2.1. Plums of cooling liquid
            1.3.5.2.2. Washing of the cooling system
            1.3.5.2.3. Filling of the cooling system
         1.3.5.3. Check of system of catching of vapors of fuel
         1.3.5.4. Check of an exhaust system
         + 1.3.5.5. Replacement of oil in an automatic transmission and the main transfer
         1.3.5.6. Replacement of oil in a makhanichesky transmission
         1.3.5.7. Check of fastening of a suspension bracket
         + 1.3.5.8. Check and replacement of spark plugs
         1.3.5.9. Check and replacement of high-voltage wires and details of the distributor
      + 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


1.3.5.2.3. Filling of the cooling system

GENERAL INFORMATION

Before filling of the cooling system make sure that all hoses and collars in a good shape. Pay attention that mix of antifreeze has to be used all the year round for prevention of corrosion. Also check that a stopper on a radiator and drain traffic jams of the block of cylinders were established into place.

PERFORMANCE ORDER

1. Install the handle of adjustment of a heater in the provision of the maximum temperature.

2. Slowly fill in cooling liquid in a radiator.

3. Without closing a radiator stopper, start the engine and warm up it up to the working temperature at which the thermostat will open and cooling liquid will start proceeding through a radiator, thus the top hose of a radiator will become hot.
4. Switch off and cool the engine, check the level of cooling liquid and, if necessary, bring it to norm.
5. Squeezing the top hose of a radiator, remove air from the engine cooling system then add cooling liquid to the demanded level. Establish a radiator stopper into place.
6. Start the engine and warm up it up to the normal working temperature and check tightness of the cooling system of the engine.