Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top Dead Point (TDP) of the piston of the first cylinder
   - 3.5. Cover of a head of the block of cylinders
      3.5.1.2. Installation
      + 3.5.2. Engine 1MZ-FE
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


3.5. Cover of a head of the block of cylinders

3.5.1. Engine 3VZ-FE

3.5.1.1. Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.

Preventions

In the presence in the code radio receiver against theft before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


2. If it is uncovered heads a back head of the block of cylinders, remove the back thermofilter, a casing of the air filter, a throttle and an air inlet.
3. If it is uncovered heads a forward head of the block of cylinders (about a radiator), remove high-voltage wires from spark plugs.
4. Separate a forward plait of wires and disconnect electric sockets from the following elements:
a) three left fuel nozzles,
b) oil pressure sensor,
c) conditioner compressor.
d) generator,
e) sensor of temperature of cooling liquid.
5. Disconnect a back plait of wires and disconnect elektriches Kia sockets from the following elements:
a) three right fuel nozzles,
b) sensor of the index of temperature of cooling liquid,
c) oxygen sensor,
d) pump of the amplifier of a steering.
6. Unscrew nuts and uncover heads of the block of cylinders.