Toyota Camry

1992-1997 of release

Repair and operation of the car

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top Dead Point (TDP) of the piston of the first cylinder
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   - 3.12. Head of the block of cylinders
      3.12.2. Installation
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

3.12. Head of the block of cylinders

3.12.1. Removal



In the presence in the code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.

1. Remove a weight wire from the accumulator.
2. Merge cooling liquid from the cooling system.
3. Remove an air inlet, pipes of supply of fuel and fuel nozzles.
4. Remove a final collector.
5. Remove the generator and the distributor of ignition.
6. Remove an inlet collector.
7. Take off a gear belt, pulleys of camshafts and the top single pulley.
8. Remove a back casing of a gear belt.
9. Remove camshafts.
10. Using a 8-millimetric key, unscrew the central bolts (on one in each head).

11. Evenly and gradually in sequence, return shown in drawing, unscrew bolts of fastening of a head of the block of cylinders.
12. Remove a head of the block of cylinders.
13. Similarly remove the second head of the block of cylinders.