Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
- 9. Transmission
   9.2. General information
   9.3. Gear shifting cables
   9.4. Gear shifting lever
   9.5. Switch of light of a backing
   - 9.6. Removal and installation of a transmission
      9.6.2. Installation
   9.7. Repair of a transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


9.6. Removal and installation of a transmission

9.6.1. Removal

PERFORMANCE ORDER
1. Remove a cowl.
2. Reduce pressure in fuel system.
3. Remove a weight wire from the accumulator.
Preventions

In the presence in the code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


4. Disconnect the electric socket, unscrew bolts and remove the executive mechanism cruise control.
5. Remove the accumulator and a support of the accumulator.
6. Remove an air inlet and a casing of the air filter.
7. Disconnect fuel-supply lines from the engine and close them traffic jams.
8. Remove the fuel filter together with an arm.
9. Remove the charcoal canister.
10. Remove a washer reservoir of a windshield and a broad tank.
11. Disconnect a cable of an accelerator and a control cable of average speed from the throttle case.
12. Mark and disconnect vacuum hoses, hoses of supply of cooling liquid, ventilation hoses, electric sockets and tires of grounding.
13. Remove radiator fans together with casings. Merge cooling liquid and remove a radiator. Disconnect hoses of supply of cooling liquid to a heater.
14. Remove a gear shifting cable from a transmission.
15. Lift the car and record on supports. Remove wheels.
16. Disconnect a reception exhaust pipe from a collector.
17. Remove mudguards.
18. Merge engine oil from the engine.
19. Take off driving belts.
20. Merge oil from a transmission.
21. Disconnect hinges of power shafts from a transmission.
22. On models with the amplifier of a steering unscrew bolts of fastening of the pump of the amplifier of a steering and move it aside, without disconnecting from it hoses.
23. On models with air conditioning unscrew bolts of fastening of the compressor and move the compressor aside, without disconnecting from it hoses.
24. On models with four-cylinder engines with the oil heater remove an oil filter and disconnect hoses from the oil heater.
25. Remove the working cylinder of coupling and hoses.
26. Hook on the power unit the load-lifting mechanism and raise so that the weight of the power unit of a vosprina matsya by the load-lifting mechanism.
27. Unscrew support of the power unit.
28. Check that anything else does not connect the power unit to a motor compartment of the car.
29. Being careful, slowly lift the power unit from a motor compartment of the car.
30. Install the power unit on wooden bars.
31. Remove a starter.
32. If necessary remove coupling and check its state.