|
|
Toyota Camry1992-1997 of releaseRepair and operation of the car |
|
|
Kamri's Toyota + General data + 1. Maintenance + 2. Engine + 3. Six-cylinder V6 engines + 4. Capital repairs of engines + 5. Cooling and heating + 6. Fuel system + 7. System of ignition + 8. Toxicity decrease + 9. Transmission + 10. Automatic transmission + 11. Coupling and power shafts + 12. Brake system + 13. Suspension bracket - 14. Body 14.1.1. Security measures when carrying out welding works + 14.2. Care of a body + 14.3. Care of an upholstery and rugs - 14.4. Repair of insignificant damages of a body 14.4.2. Repair of dents in a body design 14.4.3. Repair of the rusted openings or holes in a body design 14.4.4. Filling and painting of a body 14.5. Repair of strong damages of a body + 14.6. Cowl 14.7. Trunk lid 14.8. Back door + 14.9. Replacement of racks of support 14.10. Door upholstery + 14.11. Doors + 14.12. Lock, cylinder of the lock and handle of opening of a door 14.13. Door glass 14.14. Window regulator 14.15. Front bumper 14.16. Rear bumper 14.17. External rear-view mirrors + 14.18. Seats 14.19. Decorative overlay of a combination of devices 14.20. Casings of a steering column 14.21. Central console 14.22. Ware box 14.23. Check of a condition of seat belts 14.24. Front grille 14.25. Engine mudguard + 15. Electric equipment |
14.4.2. Repair of dents in a body design
At deep cave-in of elements of a design of a body first of all try to curve a dent back before the maximum approach to a normal form of a body. Body metal in a place of blow is exposed to a pulling therefore the complete recovery of an initial form is impossible. Optimum it is considered alignment of a dent about 3 mm lower than the level of a surrounding surface. If there is an access to dent inside, it is necessary to vystuchat accurately it a soft hammer with a wooden or plastic head. During this operation it is necessary to press to outer side of the tapped area the corresponding wooden whetstone densely. It is required for depreciation of blows of a hammer and for prevention of a flexure of more extensive area. If the dent is in that area of a body where access from a reverse side is complicated or impossible, in the deepest points of a dent drill some small openings, in openings screw up the self-cutting screws and extend a dent by means of flat-nose pliers for the acting heads of screws. Remove paint from the damaged area and at distance of 20 mm round it. Most easily it can be executed, using the wire brush or an emery paper got on the circle fixed in the electric drill. After alignment of a dent apply on it a layer of hard putty, paint and polish. |
|