Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
- 14. Body
   14.1.1. Security measures when carrying out welding works
   + 14.2. Care of a body
   + 14.3. Care of an upholstery and rugs
   - 14.4. Repair of insignificant damages of a body
      14.4.2. Repair of dents in a body design
      14.4.3. Repair of the rusted openings or holes in a body design
      14.4.4. Filling and painting of a body
   14.5. Repair of strong damages of a body
   + 14.6. Cowl
   14.7. Trunk lid
   14.8. Back door
   + 14.9. Replacement of racks of support
   14.10. Door upholstery
   + 14.11. Doors
   + 14.12. Lock, cylinder of the lock and handle of opening of a door
   14.13. Door glass
   14.14. Window regulator
   14.15. Front bumper
   14.16. Rear bumper
   14.17. External rear-view mirrors
   + 14.18. Seats
   14.19. Decorative overlay of a combination of devices
   14.20. Casings of a steering column
   14.21. Central console
   14.22. Ware box
   14.23. Check of a condition of seat belts
   14.24. Front grille
   14.25. Engine mudguard
+ 15. Electric equipment





14.4.3. Repair of the rusted openings or holes in a body design

GENERAL INFORMATION

Remove paint from the damaged area and approximately on 20 mm round it. Using a metal brush, clear the showered rust from a surface of the bared metal on the damaged area. Process the damaged area rust solvent according to its instruction. Close an opening from a rust or a hole the metal gauze or a strip of aluminum foil. Cut out the piece of a grid which is approximately corresponding to an opening form, enclose it in an opening so that its edges did not act over the level of the panel surrounding an opening. Fix it by means of several lumps of spackling paste on perimeter. Using the screw-driver handle, level the ends of a grid so that it densely adjoined to body metal. Further make filling, painting and polishing of the damaged body site.