Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   + 2.10. Camshaft and pushers
   - 2.11. Head of the block of cylinders
      2.11.2. Installation
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


2.11. Head of the block of cylinders

2.11.1. Removal

GENERAL INFORMATION

Preventions

Removal of a head of the block of cylinders needs to be made on the cold engine.

In the presence in the code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator of an otsoyeda nyatsya for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeatedly go connections of the accumulator, it is necessary to address in a specialized workshop for restoration rabotospo sobnost of system.


PERFORMANCE ORDER

1. Remove a weight wire from the accumulator.

2. Merge cooling liquid from the block of cylinders and a radiator.

3. Merge engine oil and remove an oil filter.
4. Remove the throttle case, fuel nozzles and the fuel highway.
5. Remove an inlet collector.
6. Remove a final collector.
7. Take off a gear belt, a pulley of a camshaft and the top single pulley.
8. Remove a back casing of a gear belt.
9. Remove camshafts and pushers.
10. Remove the generator and the distributor of ignition.
11. Unscrew a bolt of fastening of the pump of the amplifier of a steering and move it aside, without disconnecting from it hoses.
12. Mark and disconnect the remained pipes, hoses, cables and wires.
13. Working in sequence, return shown in drawing, weaken bolts of fastening of a head of the block of cylinders on 1/3 turns for each pass before full unscrewing of bolts.
14. Remove a head of the block of cylinders.