Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   - 2.13. Oil pump
      2.13.2. Check
      2.13.3. Installation
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


24klad.com .| 1300.



2.13. Oil pump

2.13.1. Removal

GENERAL INFORMATION

Details of the oil pump
1 – pulley;
2 – cover of the oil pump;
3 – internal rotor;
4 – sealing laying of round section;
5 – external rotor;
6 – case of the oil pump;
7 – laying;
8 – piston of the safety valve;
9 – spring;
10 – clamp;
11 – persistent ring

PERFORMANCE ORDER
1. Remove the oil pallet.
2. Unscrew nuts and remove an oil receiver pipe.
3. Support the engine a jack and remove the lower single pulley, a pulley of an auxiliary belt of a cranked shaft, a gear belt and a pulley of a cranked shaft.
4. Unscrew 12 bolts and remove the oil pump from the engine. 5. Unscrew two remained bolts and uncover the oil pump.
6. Fix in a vice with soft sponges a pulley of the oil pump and unscrew a nut of fastening of a pulley. Take an internal rotor of the oil pump.
7. Clear the interfaced surfaces of the oil pump and the block of cylinders of traces of old laying.
8. Remove a lock ring of the safety valve and take a clamp, a spring and the piston.