Toyota Camry

1992-1997 of release

Repair and operation of the car

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top Dead Point (TDP) of the piston of the first cylinder
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   - 3.11. Camshafts and pushers
      3.11.2. Check
      - 3.11.3. Installation The cam-shaft operating inlet valves of the right head The cam-shaft operating final valves of the right head
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment The cam-shaft operating final valves of the right head


The rings removed with from the camshaft operating final valves

1 – spring persistent ring;
2 – gear wheel;
3 – spring ring

1. Oil pure engine cams, necks of bearings and persistent surfaces of gear wheels of a camshaft.
2. Establish a camshaft in a head of the block of cylinders so that tags on a gear wheel (two points) were directed to the camshaft operating inlet valves.
3. Establish covers of bearings of a camshaft so that shooters were directed to forward part of the engine.
4. Tighten bolts of fastening of covers of bearings distribute a telny shaft, turning them on 1/3 turns for each pass to sequences, presented in drawing.
5. Unscrew an additional bolt from a camshaft gear wheel.
6. Similarly remove and establish camshafts on the left head of the block of cylinders.
7. Establish a gear belt.
8. Further installation is made in sequence, the return to removal.