Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top Dead Point (TDP) of the piston of the first cylinder
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   + 3.12. Head of the block of cylinders
   - 3.13. Oil pallet
      3.13.1.2. Installation
      - 3.13.2. Engine 1MZ-FE
         3.13.2.2. Installation
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


3.13.2. Engine 1MZ-FE

3.13.2.1. Removal

GENERAL INFORMATION

Preventions

In the presence in the code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


Arrangement of bolts of fastening of aluminum section of the oil pallet to the block of cylinders

PERFORMANCE ORDER
1. Uncover a maslozalivny mouth.
2. Remove a weight wire from the accumulator.
3. Lift forward part of the car and record on supports.
4. Remove an engine mudguard.
5. Merge engine oil and unscrew an oil filter.
6. Remove a reception exhaust pipe.
7. Unscrew two bolts and remove the protection cover of a case of a flywheel. 8. Unscrew two bolts fixing aluminum section of the oil pallet to a transmission.
9. Unscrew 10 bolts and two nuts fixing steel section of the oil pallet and remove it.
10. Remove an oil receiver pipe with the mesh filter.
11. Unscrew 17 bolts fixing aluminum section of the oil receiver to the block of cylinders and remove it (see rice. An arrangement of bolts of fastening of aluminum section of the oil pallet to the block of cylinders).