Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top Dead Point (TDP) of the piston of the first cylinder
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   - 3.8. Gear belt and pulleys
      3.8.2. Check
      3.8.3. Installation
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


3.8.2. Check

GENERAL INFORMATION

Preventions

Do not overwind and do not bend a gear belt. Exclude hit on a gear belt of oil, cooling liquid or fuel.

If there was a rupture of a gear belt on the working engine, it is possible that there was an impact of pistons about the valve therefore the valve can be bent. Check gaps of valves. On the bent valves valvate gaps will be much more demanded.


PERFORMANCE ORDER

1. Remove single pulleys and check a condition of their podshipna of k. Check a condition of a spring and check spring dyne in a free state.

2. If there was a vykrashivaniye of teeths of a gear belt, perhaps, the ignition distributor, the water pump, the oil pump or a camshaft are jammed.

3. If there is a considerable wear or stratification on an external surface of a gear belt, check a condition of a racetrack of single pulleys.
4. If there is a wear or damage only on one party of a belt, check directing a gear belt and alignment of pulleys of a gear belt.
5. Check the mechanism of a tension of a gear belt for existence of leak of liquid.
6. Pressing a tension mechanism pusher, check tightness of the mechanism of a tension and lack of the course of a pusher. If the pusher enters the tension mechanism, replace the tension mechanism. 7. Check a pusher vystupaniye from the tension mechanism case. If the vystupaniye of a pusher differs from demanded, replace the tension mechanism.