Repair and operation of the Toyota Camry car - 7.14. Starter//Kamri's Toyota of 1992-1997 /

Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
- 7. System of ignition
   7.2. Accumulator
   + 7.3. System of ignition
   + 7.4. Check of system of ignition
   + 7.5. Ignition coil
   + 7.6. Ignition distributor
   7.7. Check and adjustment of a corner of an advancing of ignition
   7.8. Block of ignition (switchboard)
   + 7.9. Sensor of impulses
   7.10. System of charging
   7.11. Generator
   7.12. Check and replacement of components of the generator
   7.13. System of start of the engine
   7.14. Starter
   7.15. Traction relay
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


Êîíñóëüòàöèÿ þðèñòà

7.14. Starter

GENERAL INFORMATION

Preventions

In the presence in the code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.



Starter
 
1 – case of a starter and coupling;
2 – gear wheel;
3 – lock ring;
4 – bearing;
5 – spring;
6 – holder of a spring;
7 – starter case;
8 – obgonny coupling;
9 – spring;
10 – shaft;
11 – traction relay;
12 – spring;
13 – bearing;
14 – gear wheel;
15 – steel ball;
16 – forward bearing;
17 – rotor;
18 – back bearing;
19 – sealing ring;
20 – stator;
21 – sealing ring;
22 – shchetkoderazhtel;
23 – back cover;
24 – dustproof cover;
25 – sealing ring

Starter relay arrangement in the relay block

 


PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Remove the accumulator from a motor compartment.
3. Disconnect and remove the executive block cruise control from a motor compartment.
4. Disconnect electric wires from a starter and the traction relay.
5. Unscrew bolts of fastening of a starter.
6. Being careful, remove a starter from the engine.
7. Installation is made in sequence, the return to removal.