Toyota Camry

1992-1997 of release

Repair and operation of the car


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
- 7. System of ignition
   7.2. Accumulator
   + 7.3. System of ignition
   - 7.4. Check of system of ignition
      7.4.2. System of ignition without ignition distributor
   + 7.5. Ignition coil
   + 7.6. Ignition distributor
   7.7. Check and adjustment of a corner of an advancing of ignition
   7.8. Block of ignition (switchboard)
   + 7.9. Sensor of impulses
   7.10. System of charging
   7.11. Generator
   7.12. Check and replacement of components of the generator
   7.13. System of start of the engine
   7.14. Starter
   7.15. Traction relay
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


7.4. Check of system of ignition

7.4.1. System of ignition with the ignition distributor
PERFORMANCE ORDER
1. If the engine is turned by a starter, but not started, remove a high-voltage wire from any candle and, using the tool with the isolated handles, place the end of a wire at distance of 6 mm from weight.
2. Turning the engine a starter, check that in an interval between a wire and weight the spark slips.
3. If the spark is present, so on a spark plug tension moves. Similarly check presence of a spark on other cylinders.
4. In the absence of a spark and availability of moisture on a distributor cover, dry a cover and a rotor of the distributor, establish them on a place and repeat check.
5. Boots of natyazhitel have to rotate freely on axes. If on them there are cracks, chips or considerable wear of a working surface, they need to be replaced.
6. If the spark still is absent, remove the central high-voltage wire from a cover of the distributor and place the end of a wire at distance of 6 mm from weight and repeat check.
7. If the spark appeared, means high-voltage wires to candles, a cover or a rotor of the distributor are faulty.
8. If the spark still is absent, check connection of primary winding of the coil of ignition and giving of tension not the coil of ignition from the ignition lock.
9. If the spark still is absent, check integrity of the central high-voltage wire, having measured its resistance or having replaced a wire.
10. If the spark still is absent, means the control unit of ignition is faulty (switchboard).