Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
- 7. System of ignition
   7.2. Accumulator
   + 7.3. System of ignition
   + 7.4. Check of system of ignition
   + 7.5. Ignition coil
   + 7.6. Ignition distributor
   7.7. Check and adjustment of a corner of an advancing of ignition
   7.8. Block of ignition (switchboard)
   + 7.9. Sensor of impulses
   7.10. System of charging
   7.11. Generator
   7.12. Check and replacement of components of the generator
   7.13. System of start of the engine
   7.14. Starter
   7.15. Traction relay
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


7.7. Check and adjustment of a corner of an advancing of ignition

GENERAL INFORMATION

Tools necessary for check and adjustment of a corner of an advancing of ignition

1 – vacuum traffic jams which need to be used for closing of the vacuum hoses disconnected during check of a corner of an advancing of ignition;
2 – stroboscope;
3 – wrench necessary for weakening of a bolt of fastening of the distributor of ignition


PERFORMANCE ORDER
1. Connect a tachometer according to the instruction of manufacturer. 2. Using an additional wire, connect contacts of E1 and TE1 of the control socket.
3. Connect a stroboscope according to the instruction of manufacturer. Establish a measuring wire of a stroboscope on a high-voltage wire of the first cylinder.
4. Combine adjusting tags on a casing of a gear belt and a pulley of a cranked shaft. 5. Start the engine, warm up it up to the normal working temperature and measure idling turns. Direct light of a stroboscope on the index with a scale of an advancing of ignition and a pulley of a cranked shaft. Thus the tag on a pulley has to be combined with S tag on an index scale. If it is necessary, weaken a bolt of fastening of the distributor of ignition and slowly turn the ignition distributor until the tag on a pulley of a cranked shaft is not combined with S tag on the index.
6. Remove the additional closing wire with a diagnosticha of the sky socket and check that the corner of an advancing of ignition moved from 12 to 22 degrees forward.
7. Switch off the engine and remove a tachometer and a stroboscope.