Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   - 2.10. Camshaft and pushers
      + 2.10.1.1. The camshaft operating final valves
      2.10.2. Check
      + 2.10.3. Installation
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


2.10.2. Check

PERFORMANCE ORDER
1. Measure distance between the ends of a spring ring of fastening of a gear wheel on distributive to a shaft.
2. Mark and take pushers together with regulirovoch ny plates.
3. Examine each pusher on existence of wear and scratches.
4. Check working surfaces of bearings the distributor of ny shaft and contours of cams of camshafts for wear. With any wear replace a camshaft.

5. Using a micrometer, measure height of cams of camshafts...
6.... and diameters of necks of bearings of camshafts.
7. Check a working gap of bearings of a camshaft as follows.
7a. Clear covers of bearings and a neck of a camshaft.
7b. Establish a camshaft in a head of the block of cylinders, thus do not establish pushers and do not grease a camshaft.
7v. Cut off a slice of a plastic core of Plastigage (it has to be slightly shorter, than bearing width) and establish on a camshaft neck.
7g. Establish a bearing cover, thus the arrow on a cover of the bearing has to be directed to forward part of the engine.
7d. Tighten bolts of fastening of a cover of the bearing of a camshaft the demanded moment and in stages.
Prevention

In the course of measurement of a working gap by Plastigage method do not rotate a camshaft.


7e. Unscrew bolts and uncover the camshaft bearing.
7zh. Apply a large-scale ruler to the deformed plastic core. Comparing width of the deformed plastic core to control width on a large-scale ruler, determine the size of a working gap.

7z. In end carefully clear Plastigage-material traces from bearings and a camshaft.

8. Temporarily establish camshafts without tolkata pour into a head of the block of cylinders and measure a side play between teeths of gear wheels of camshafts.