Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   - 2.10. Camshaft and pushers
      + 2.10.1.1. The camshaft operating final valves
      2.10.2. Check
      - 2.10.3. Installation
         2.10.3.2. The camshaft operating final valves
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


2.10.3. Installation

2.10.3.1. The camshaft operating inlet valves

PERFORMANCE ORDER
1. Oil pushers pure engine and establish them into place. Check that adjusting laying of ustan of Lena in pushers.
2. Grease necks of bearings and cams of a camshaft with pure engine oil.


3. Establish a camshaft in a head of the block of cylinders so that the adjusting pin was turned on 80 ° from the vertical line to the left.
4. Apply a thin film of sealant on the interfaced surface of a forward cover of a camshaft according to drawing.
5. Establish covers of bearings of a camshaft according to tags, and shooters have to be directed to forward part of the engine.
6. Gradually and consistently in the order shown in drawing tighten bolts of fastening of covers of bearings of a camshaft.
7. Establish a new oil sealing ring of a camshaft.