|
1. Turn camshafts in such situation that the adjusting pulley of the camshaft operating final valves was on 10-45 ° from the vertical line to the left. |
|
|
2. Screw in an additional bolt of M 6 x 1 about 20 mm long in a gear wheel of the camshaft operating vypuskna mi valves. |
| 3. Unscrew a bolt of fastening of a back cover of the bearing of the camshaft operating final the valve mi and uncover. |
| 4. Unscrew bolts of fastening of covers of bearings distribute a telny shaft No. 1, 2 and 4 on a half of a turn for each pass before full unscrewing of bolts. Remove the 1st, 2nd and 4th cover of bearings of a camshaft. |
| 5. Gradually and consistently unscrew bolts of fastening of a cover of the bearing No. 3 of a camshaft and uncover. |
| 6. Remove a camshaft from a head of the block of cylinders. |