Toyota Camry

1992-1997 of release

Repair and operation of the car

Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   - 2.10. Camshaft and pushers
      - 2.10.1.1. The camshaft operating final valves
         2.10.1.2. The camshaft operating inlet valves
      2.10.2. Check
      + 2.10.3. Installation
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

�� : https://worldland24.ru

2.10.1.2. The camshaft operating inlet valves

PERFORMANCE ORDER

	1. Turn a camshaft in such situation that the adjusting pin was placed on 80–115 ° from the vertical plane to the left.
2. Unscrew bolts of fastening of a forward cover of the bearing of a camshaft and uncover the bearing with condense with a telny ring.
3. Unscrew bolts of fastening of covers of bearings distribute a telny shaft No. 1, 3 and 4 on a half of a turn for each pass before full unscrewing of bolts. Remove the 1st, 3rd and 4th cover of bearings of a camshaft.
4. Gradually and consistently unscrew bolts of fastening of a cover of the bearing No. 2 of a camshaft and uncover.
5. Remove a camshaft from a head of the block of cylinders.