Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Cooling system hoses
   + 5.5. Check and replacement of the thermostat
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   + 5.11. Sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Heater fan resistor
   5.14. Heater radiator
   + 5.15. Control panel heater
   5.16. Air conditioning system
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


5.12. Heater fan

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. The fan is located on the right side under the dashboard.
3. Remove a ware box, a cover of a ware box and the lower finishing of the panel under a ware box.
4. Disconnect from the heater fan engine elektriches a cue the socket and on contacts of the engine give additional wires tension from the accumulator. If the engine does not work, replace the engine.
5. If the engine works, connect additional wires to the fan socket a bulb. Include ignition, turn the handle of turning on of the fan and check to a postupla of scientific research institute of tension to the socket.
6. For removal of the fan unscrew screws and lower the heater fan down. On models with engines 1MZ-FE unscrew two screws and disconnect electric sockets of a plait of wires for simplification of access to the fan.
7. Installation is made in sequence, the return to removal.