Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Cooling system hoses
   + 5.5. Check and replacement of the thermostat
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   - 5.10. Water pump
      5.10.2. Models with V6 engines
   + 5.11. Sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Heater fan resistor
   5.14. Heater radiator
   + 5.15. Control panel heater
   5.16. Air conditioning system
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


5.10. Water pump

5.10.1. Models with four-cylinder engines

GENERAL INFORMATION

Arrangement of a bolt of fastening of adjusting draft of the generator

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.

Preventions

In the presence in the code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


2. Take off a gear belt and single pulleys.
3. Unscrew adjusting draft of the generator (see rice. Arrangement of a bolt of fastening of adjusting draft of the generator).
4. Unscrew bolts of fastening of the water pump and remove the pump together with laying.
5. Disconnect bypass a cooling system hose from a branch pipe, unscrew two nuts of fastening of a branch pipe of supply of cooling liquid to a heater and uncover the pump.
6. Clear all interfaced surfaces of the water pump.
7. Install the water pump with new laying on the block of cylinders and fix bolts in the sequence shown in drawings.
8. Establish new laying on the thermostat.
9. Further installation is made in sequence, the return to removal.