Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Cooling system hoses
   + 5.5. Check and replacement of the thermostat
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   + 5.11. Sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Heater fan resistor
   5.14. Heater radiator
   - 5.15. Control panel heater
      5.15.1. Adjustment of a cable of management
      5.15.2. Check of an electric chain
   5.16. Air conditioning system
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment





5.15. Control panel heater

GENERAL INFORMATION

Control panel elements heater
And – the handle of adjustment of temperature;
In – a cable of management of a heater;
With – the fan switch;
D – electric socket

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.

Preventions

In the presence in the code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


2. Remove decorative finishing of a combination of devices and remove the radio receiver.
3. Remove handles of management.
4. Unscrew 4 screws of fastening of the control panel a heater.
5. Take the control panel a heater forward. Thus the handle of adjustment of temperature has to remain on a place (see rice. Control panel elements heater).
6. Installation is made in sequence, the return to removal.