Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Cooling system hoses
   + 5.5. Check and replacement of the thermostat
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   + 5.11. Sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Heater fan resistor
   5.14. Heater radiator
   + 5.15. Control panel heater
   5.16. Air conditioning system
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment





5.14. Heater radiator

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.

Preventions

In the presence in the code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


2. Merge cooling liquid from the cooling system.
Working in a motor compartment, disconnect hoses of supply of cooling liquid to a heater.
3. Turn off a heater carpet from the driver.
4. Release two brackets and remove a protective plate of a heater. 5. Unscrew three screws, remove clips and remove tubes of supply of cooling liquid to a heater radiator.
6. Take a heater radiator from a nest.
7. Installation is made in sequence, the return to removal. Fill in cooling liquid in the cooling system.