Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Cooling system hoses
   + 5.5. Check and replacement of the thermostat
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   - 5.10. Water pump
      5.10.2. Models with V6 engines
   + 5.11. Sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Heater fan resistor
   5.14. Heater radiator
   + 5.15. Control panel heater
   5.16. Air conditioning system
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment





5.10.2. Models with V6 engines

GENERAL INFORMATION

Arrangement of brackets of fastening of a plait of wires to a back casing of a gear belt

Places of drawing a layer of sealant in a flute of the interfaced surface of the water pump

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator and merge cooling liquid from the engine cooling system.
2. Take off a gear belt.
3. Unscrew a bolt, the fixing thermostat casing to an adjusting level of the generator and remove a casing of the thermostat and the thermostat. On engines 1MZ-FE remove a back casing of a gear belt (see rice. An arrangement of brackets of fastening of a plait of wires to a back casing of a gear belt).
4. Unscrew bolts and nuts of fastening of the water pump and remove the water pump. On the engine 1MZ-FE there are two long racks which need previously to be unscrewed.
5. Clear all interfaced surfaces of the water pump.
Put a layer of sealant with a diameter of 2-3 mm in a flute of the interfaced surface of the water pump (see rice. Places of drawing a layer of sealant in a flute of the interfaced surface of the water pump). On the engine 1MZ-FE instead of sealant use rubber laying.
6. Install the water pump on the engine and fix bolts, having tightened them the demanded moment.
7. Further installation is made in sequence, the return to removal. Fill in cooling liquid in the engine cooling system.