Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
- 13. Suspension bracket
   13.2. General information
   + 13.3. Forward stabilizer of cross stability
   + 13.4. The lobby is resistant
   13.5. Repair of a forward rack
   + 13.6. Lower lever of a forward suspension bracket
   13.7. Replacement of the lower hinge of a forward suspension bracket
   + 13.8. Rotary fist
   13.9. Back stabilizer of cross stability
   + 13.10. Rack of a back suspension bracket
   13.11. Longitudinal draft of a back suspension bracket
   + 13.12. Levers of a back suspension bracket
   - 13.13. Nave of a back suspension bracket
      13.13.2. Installation
   + 13.14. Fastener of a back nave
   + 13.15. Steering wheel
   + 13.16. Tips of steering draft
   13.17. Replacement of protective covers of steering transfer
   + 13.18. Steering transfer
   + 13.19. Pump of the amplifier of a steering
   13.20. Removal of air from system of a steering with the amplifier
   + 13.21. Wheels and tires
   13.22. Corners of installation of wheels
+ 14. Body
+ 15. Electric equipment


13.13. Nave of a back suspension bracket

13.13.1. Removal

GENERAL INFORMATION

Details of a nave of a back suspension bracket
1 – nave;
2 – nave bolt;
3 – bearing;
4 – nut;
5 – nave of a back suspension bracket assembled;
6 – sealing ring of round section;
7 – support;
8 – brake disk;
9 – brake drum

PERFORMANCE ORDER
1. Lift back part of the car and record on supports. Remove a wheel.
2. On models with back disk brakes remove a brake support. Remove the brake drum or a brake disk from a nave.
3. Unscrew 4 bolts of fastening of an axis of a nave to the nave fastener. Thus turn a nave flange so that openings in a flange were established opposite to fastening bolts.
4. Remove a nave of a back suspension bracket.
5. Remove a sealing ring of round section from the nave axis basis.
6. Unscrew a nut of fastening of a nave, take a nave from the bearing and, if necessary, replace bearings. Install a nave in bearings and tighten a fastening nut the demanded moment.