Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Capital repairs of engines
   4.2. General information
   4.3. Check of a compression
   4.4. Recommendations about removal of the engine
   + 4.5. Removal and installation of the engine
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a cranked shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Cranked shaft
   + 4.15. Survey and choice of radical and shatunny bearings
   4.16. Control of a side play of assembly of the balance weight (engine 5S-FE)
   4.17. Balance of assembly of the engine at capital repairs
   4.18. Installation of piston rings
   + 4.19. Installation of a cranked shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a cranked shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Start of the engine after capital repairs
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


4.11. Removal of a cranked shaft

GENERAL INFORMATION

Prevention

The cranked shaft can be removed only from the engine removed from the car. It is also previously necessary to remove a flywheel, a quencher of tortional fluctuations, a gear belt, the oil pallet, an oil receiver pipe with the mesh filter, the oil pump, pistons and rods, and a back cover of a cranked shaft.


PERFORMANCE ORDER
1. Before removal of a cranked shaft measure its axial side play with use of the indicator of hour type.
2. Move a cranked shaft back against the stop and install the indicator of hour type on 0. Then move a cranked shaft forward against the stop and write down indications of the indicator. If the axial side play is more admissible, check the surfaces of a cranked shaft adjacent to persistent half rings, for wear. If wear is not recorded, replace only persistent half rings.
3. Measurement of an axial side play of a cranked shaft can also be performed with use of edges of the probe.
4. Mark covers of radical bearings.
5. Gradually and consistently unscrew bolts of fastening of covers of radical bearings. On the engine 3VZ-FE V6 of a cover of radical bearings are executed as the uniform block. On the engine 1MZ-FE V6 bolts of fastening of the block of covers of radical bearings are established the block on each side.
6. Remove a cranked shaft from the block of cylinders of the engine.