Toyota Camry

1992-1997 of release

Repair and operation of the car


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Capital repairs of engines
   4.2. General information
   4.3. Check of a compression
   4.4. Recommendations about removal of the engine
   + 4.5. Removal and installation of the engine
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a cranked shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Cranked shaft
   + 4.15. Survey and choice of radical and shatunny bearings
   4.16. Control of a side play of assembly of the balance weight (engine 5S-FE)
   4.17. Balance of assembly of the engine at capital repairs
   4.18. Installation of piston rings
   + 4.19. Installation of a cranked shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a cranked shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Start of the engine after capital repairs
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


4.6. Sequence of dismantling of the engine
GENERAL INFORMATION

Removal of the right suspension bracket of the power unit

 
Prevention

At dismantle of the specified details pay attention to features of their removal. Remember positions of installation of laying, sealing rings, pro-rates, pins, arms, washers, bolts and other fine details.

Installation of the engine on the special stand considerably facilitates assembly dismantling processes. Before installation of the engine shoot a flywheel and a back sealing ring with the stand.

In the absence of the stand dismantling of the engine on a floor is possible. At work in these conditions observe extra care.

If you got the restored engine, on it from the old engine it is necessary to rearrange the following knots:

– generator and arms;
– details of control of emission of exhaust gases;
– ignition distributor; spark plugs and vysokovolt ny wires;
– thermostat and cover of the thermostat;
– water pump;
– EFI system elements;
– inlet and final collectors;
– oil filter;
– suspension brackets of the power unit;
– coupling and flywheel

If you plan complete capital repairs of the engine, disassemble the engine on the making details in the following order:

– inlet and final collectors;
– cover of a head of the block of cylinders;
– casings of a gear belt;
– gear belt and pulleys;
– heads of the block of cylinders;
– oil pallet;
– oil pump;
– assembly of the balance weight (engines 5S-FE);
– pistons and rods;
– back cover of a cranked shaft;
– cranked shaft and radical bearings.