Toyota Camry

1992-1997 of release

Repair and operation of the car



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Capital repairs of engines
   4.2. General information
   4.3. Check of a compression
   4.4. Recommendations about removal of the engine
   + 4.5. Removal and installation of the engine
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a cranked shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Cranked shaft
   - 4.15. Survey and choice of radical and shatunny bearings
      - 4.15.2. Choice
         4.15.2.1. Radical bearings
         4.15.2.2. Shatunny bearings
         4.15.2.3. All bearings
   4.16. Control of a side play of assembly of the balance weight (engine 5S-FE)
   4.17. Balance of assembly of the engine at capital repairs
   4.18. Installation of piston rings
   + 4.19. Installation of a cranked shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a cranked shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Start of the engine after capital repairs
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Toxicity decrease
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment





4.15.2.1. Radical bearings

GENERAL INFORMATION

Arrangement of tags of identification of radical bearings on the engine 3VZ-FE V6

Arrangement of tags of identification of radical bearings on the engine 5S-FE

Arrangement of tags of identification of radical bearings on forward part of the block of cylinders (And) and on a forward counterbalance of a cranked shaft (In) on the engine 1MZ-FE V6

If number on the radical bearing is jammed, read it on the surface of the block of cylinders interfaced to the oil pallet. On the engine 1MZ-FE V6 of number of the block are on forward part of the block of cylinders about the first radical bearing, and numbers of a cranked shaft are on the first counterbalance of a cranked shaft.

Summation of number on the block of cylinders with number of a neck of a cranked shaft will give the recommended bearing size for engines 5S-FE and 3VZ-FE. For determination of the size of the bearing on the engine 1MZ-FE it is necessary to use the table.

Determination of the size of the radical bearing for the engine 1MZ-FE
Total – Number of a tag
Block of cylinders (And)
+
Cranked shaft (In)
0 – 5
6 – 11
12 – 17
18 – 23
24 – 28
The used bearing
1
2
3
4
5